Ok guys/gals...
I am at my office and I was able to log into the router.
Router = Lynksis WRT54G
Under the "setup" tab, I see the following subtabs:
Basic setup, ddns, mac address clone, advanced routing.
I'm thinking I need to get into the "mac address clone" section?
That's where I see "enable" and "disable" buttons.
Right now, it's set to "disable".
Is this where I need to change the last 2 digits?
00.14.BF.05.XX.XX
Those are the values but are grayed out due to this being "disabled".
Am I in the right section?
PS: Vic - as you mentioned,
"If you aren't 192.168.1.1, try viewing the status of your connection in network settings. find out your local ethernet ip address. Your router is usually going to be the same IP as your ethernet IP but change the last digit to 0 or 1 and paste the entire address into your browser."
Since I am wireless, I checked my wireless network connection status and the IP address is different from the router. My IP is 192.168.xx.xxx
The ip address of the router = 69.116.xxx.xx
Last edited by TermedPS; 06-18-2009 at 12:59 PM.
Reason: added info
| 
